Wall Tent Internal Frame

Idaho Canvas wall tent frames are available for many sizes. Our internal frames can be constructed using 1" EMT steel, galvenized tubing. The 3/4" square steel corner fittings are inserted inside the 1" square or round tubing lengths at the eave and ridge junctures. Larger tent frame sizes should have double or triple rafter supports for added roof tability. This frame is free standing, however, for maximum stability we recommend using the adjustable guy ropes and stakes provided on our wall tents.

3/4" square, steel corner angles telescope inside 1" EMT round conduit for lighter weight, easy fit, and minimal wear points.

To minimize the cost of the internal frame and to save on shipping costs, we sell the corner angles only and suggest that you purchase the 1" EMT round conduit, galvanized steel from a local hardware store (Lowe's or Home Depot) or electrical contractor supplier. Cut dimensions are provide below for some specific tent sizes. Rubber tips are provided for each leg.

To set up your wall tent using an internal frame:

Lay out all the parts on the ground in the approximate location they will go.

Construct the top half of the frame according to the picture above.

Place tent over the constructed half of the frame. Make sure the door will open toward the direction you wish.

Lift up one side of the frame and install the side legs, then lift the opposing side of the frame and install the remaining side legs.

Pull down the walls of the tent to the ground.

Secure guide ropes and tent to the ground with tent pegs.

Wall Tent Internal Frame Cut Dimensions.

Width	Length	Wall Height	Center Peak Height	Center Roof Supports	Cut Dimensions Order angle kit
8'	10'	4	7' 9"	Single	8' x 10' x 4' x 7'9"
9'	12'	4'	8'	Single	9' x 12' x 4' x 8'
10'	12'	5'	9'	Single	10' x 12' x 5' x 9'
12'	14'	5'	9'	Double	12' x 14' x 5' x 9'
12'	16'	5'	9'	Double	12' x 16' x 5' x 9'
14'	16'	5'	9' 6"	Double	14' x 16' x 5' x 9'6"
16'	20'	5'	10' 6"	Triple	16' x 20' x 5' x 10'6"

*S = Single Support / DS = Double Support / TS = Triple Support

Welded Corner Angles

14.85 ea.